Filter
Top Products
Section 22
258 HotSync® Operations
means that you cannot use your cradle again until you
reconfigure the HotSync Manager to communicate with the
port defined for cradle synchronization.
Performing an IR HotSync operation
After you complete the steps to prepare for performing an IR
HotSync operation, it is easy to perform the actual operation.
To perform an IR HotSync operation:
1. Tap the Applications Launcher icon .
2. Tap the HotSync icon .
3. Tap “Local”.
4. Tap the drop down menu below the HotSync icon and
select “IR to a PC/Handheld”.
5. Position the IR port of your handheld within a couple of
inches of the infrared port of your computer.
6. Tap the ”HotSync” icon to start the IR HotSync operation.
Returning to cradle HotSync operations
1. If needed, connect the cradle to a serial (COM) port of
your computer.
2. Click the HotSync Manager icon in the Windows system
tray.
3. Choose “Setup”, and then click “Local”.
4. Select the COM port where your cradle is connected.
5. Click “OK”.