Filter
Top Products
234
Safety
give additional protection to the public and to account for any
variations in measurements.
Tests for SAR are conducted using standard operating positions
specified by the FCC with the phone transmitting at its highest
certified power level in all tested frequency bands. Although
SAR is determined at the highest certified power level, the
actual SAR level of the phone while operating can be well
below the maximum value. Because the phone is designed
to operate at multiple power levels to use only the power
required to reach the network, in general, the closer you are to
a wireless base station antenna, the lower the power output.
Before a phone model is available for sale to the public, it must
be tested and certified to the FCC that it does not exceed
the limit established by the governmentadopted requirement
for safe exposure. The tests are performed in positions and
locations (e.g., at the ear and worn on the body) as required by
the FCC for each model.
This device was tested for typical body-worn operations with
the back of the phone kept 0.79 inches (2.0 cm) between the
user’s body and the back of the phone. To comply with FCC
RF exposure requirements, a minimum separation distance of
0.79 inches (2.0 cm) must be maintained between the user s
body and the back of the phone. Third-party belt-clips, holsters,
and similar accessories containing metallic components should
not be used. Body-worn accessories that cannot maintain 0.79
inches (2.0 cm) separation distance between the user’s body
and the back of the phone, and have not been tested for typical
body-worn operations may not comply with FCC RF exposure
limits and should be avoided.
The FCC has granted an Equipment Authorization for this model
phone with all reported SAR levels evaluated as in compliance