Filter
Top Products
Select Navigation to view navigating information to your
trip destination, Position to view positioning information
about your current location, or Trip dist. to view your
travelling information such as the distance and duration
you have travelled, and your average and maximum
speeds.
The application must receive positioning information
from at least three satellites to be used as a travelling aid.
The trip meter has limited accuracy, and rounding errors
may occur. Accuracy can also be affected by availability
and quality of GPS signals.
Use GPS data
To check the signal strength of the satellites that provide
the positioning information necessary for navigation,
open any of the three views and select Options >
Satellite status.
To set a landmark or location as the destination of your
trip, select Navigation > Options > Set destination.
You can also enter the destination latitude and longitude
coordinates.
To remove the destination set for your trip, select
Navigation > Options > Stop navigation.
To save your current position as a landmark, select
Navigation or Position, and Options > Save position.
To activate the trip meter, select Trip dist. > Options >
Start. To stop the trip meter, select Options > Stop.
To reset all fields and start calculating the trip again, select
Trip dist. > Options > Restart.
To change the measuring system in use, select Options >
Settings > Measurement system > Metric or
Imperial.
To enter the altitude calibration to correct the altitude
received from the positioning satellites, select Options >
Settings > Altitude calibration.
Landmarks
Select Menu > Tools > Landmarks.
Landmarks are coordinates to geographic locations that
you can save to your device for later use in different
location-based services. You can create landmarks using a
Bluetooth GPS accessory or network (network service).
Create a landmark
To create a landmark, select Options > New landmark.
Select Current position to make a network request for the
latitude and longitude coordinates of your current
location, Use map to select the location from a map, or
Enter manually to fill in necessary location information
such as a name, category, address, latitude, longitude, and
altitude.
To show the landmark on the map, select Options >
Show on map.
Edit landmarks
To edit a landmark, select Options > Edit > Options and
from the following:
86