Filter
Top Products
Connecting to a Computer
Before connecting your device to a computer, check the following.
ᮣ
ActiveSync
®
is on your computer. (For installation procedures of
ActiveSync
®
, see page 85.)
ᮣ
The device is turned off.
ᮣ
The computer you’re connecting has an available USB port for the
cradle.
To connect using the supplied USB cradle:
1.
Connect the USB cradle to your computer as shown in the illustration
below.
2. Insert the device into the USB cradle.
Setup Options
Method of Setting Card into SD Card Slot
Inserting a card:
1.
Turn off the power.
2. Insert the card with its contact surface (metal contact surface) facing
backward into the device.
Note: An SD dummy card is loaded in the SD card slot at purchase.
Remove the SD dummy card before inserting the card.
Removing a card:
1.
Make sure that no application is accessing the SD card.
2. Turn off the power.
3. Lightly press down on the card until a clicking sound is heard. The card
will pop out slightly from the slot.
4. Pull the card straight up to remove.
USB port
Contact surface
Section 2: Understanding Your Device
2A: Your Device - The Basics 27
Section 2: Understanding Your Device
26 2A: Your Device - The Basics
SPRINT~1-S2Aa.QXD 02.8.6 5:58 PM Page 26