Toshiba 2032SP Cell Phone User Manual


 
SAFE USE AND OPERATION OF DEVICE (WIRELESS
HANDHELD PHONE)
Read this information before using your device.
Your device is a low power radio transmitter and receiver. When it is
ON, it receives and also sends out radiofrequency (RF) signals.
FCC RF EXPOSURE INFORMATION
In August 1996, the Federal Communications Commission (FCC) of
the United States, with its action in Report and Order FCC 96-326,
adopted an updated safety standard for human exposure to
radiofrequency (RF) electromagnetic energy emitted by FCC regulated
transmitters. Those guidelines are consistent with the safety standard
previously set by both U.S. and international standards bodies. The
design of this device complies with the FCC guidelines and these
international standards.
Use only the supplied or an approved antenna. Unauthorized antennas,
damaged antennas, modifications, or attachments could impair call
quality, damage the phone, or result in violation of FCC regulations.
Please contact your local dealer for replacement antenna.
Body-worn Operation
This device was tested with the Softcase with Belt Clip offered by Sprint,
as an accessory to this device and was found to comply with the FCC
exposure requirements. Other third-party belt clip and softcase or
holsters have not been tested with this device and therefore their
compliance with the FCC RF exposure limits cannot be confirmed.
When operating this device, a minimum separation distance of 1 inch
(2.5 cm) must be maintained between the user’s body and the device,
including its antenna, to comply with the FCC exposure limits.
This particular device has not been designed for held-to-ear use and
should never be used against the ear. It is designed to be used in a belt
clip with a Phone Headset or as a speakerphone.
For more information about RF exposure, please visit the FCC website
at www
.fcc.gov.
Section 4: Safety Guidelines and Warranty Information
4A: Safety 183
expressly approved by us or parties authorized by us could
void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Product Name: USB Cradle
Model Number(s): CEX0208B (CRU2032B)
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Section 4: Safety Guidelines and Warranty Information
182 4A: Safety
SPRINT~Section3.QXD 02.8.6 6:58 PM Page 182