A SERVICE OF

logo

Open as PDF
next previous
• Determine the center in the X-axis direction of the workpiece
Step 1 Set up using keys so that the counter starts counting from zero in the X-axis at
the time the touch signal probe comes into contact with the reference surface of
the workpiece. (For centering, it is not necessary to correct for the radius of the
probe ball tip.)
Step 2 After setting us a function of holding the display move the touch signal probe to
the opposite end, and bring it into contact. The displayed value at this time is the
dimension of the workpiece, including the ball tip diameter of the probe. If this
value is halved, the center point of the measured dimension is displayed.
No. 99MBE032A
3-14