Mitutoyo 99MBE032A5 Manual

A SERVICE OF

next previous

NOTE

1. Features of ABS and INC coordinates on the X-axis

• The reference point in the ABS coordinate is designated as the center of a

workpiece. Therefore, the display value in the ABS coordinate indicates the diameter

of the workpiece.

• In the INC coordinate zero-setting and presetting can be performed at an arbitrary

position. For example, this function allows the real-time depth of cut to be displayed

by zero-setting on a workpiece surface.

Coordinate features

Reference point of

coordinate (0 point)

Zero-setting/presetting Display

content

ABS coordinate Center of a workpiece Disabled Diameter

INC coordinate Arbitrary position on a

workpiece

Enabled Depth of cut

Appropriate use of two coordinates

2. Features of ABS and INC coordinates on the Y- and Z-axis

Although there is no functional difference between the ABS and INC coordinates on

each axis, it is recommended to use the coordinate separately as shown in the figure

below.

No. 99MBE032A

3-34