A SERVICE OF

logo

3.2.14 Addition mode
This function applies only to the 3-axis counter.
By setting parameter 43, the KA counter will display the summed value of the Y- and
Z-axis display values on the Y-axis display. (For information about parameter setup, refer
to the appropriate parameter section.)
An example of using the addition mode
This mode is used if the feed table consists of two stages.
If the addition mode has been set, “o” is displayed in the position of the most significant
digit of the Z-axis display. Other digits on the Z-axis display are unlit.
No. 99MBE032A
3-26