A SERVICE OF

logo

4. PARAMETERS
Note 2) This is the function to prevent the scale unit from being damaged due to excessively
feeding the table. However, this function is valid only when the AT700 series is connected
with this counter. Determine this value after setting Parameter 33 (Machine origin offset
value). This setting must be in mm. When the preset value is exceeded, the display value
will flash.
When this function is not used, set the lower limit (Parameter 20) to -9999.999 and upper
limit (Parameter 21) to 99999.999, respectively.
No. 99MBE032A
4-5