3. BASIC OPERATIONS
- Restrictions when the addition mode is set -
Origin and touch signal setup operations
If the addition mode is selected, the touch signal SET/HOLD and origin SET/HOLD
functions on the Y- and Z-axis cannot be used.
Example No. 1
[ Y ] The buzzer sounds twice.
Example No. 2
[TSP]
[HOLD]
[Z] The buzzer sounds twice.
The X-axis touch signal HOLD function can be used.
Presetting
• The presetting operation for only the Z-axis cannot be performed. The buzzer sounds
twice if the Z-axis designation key is pressed.
• If the Y-axis presetting operation is performed, a preset value will be stored for the
Y-axis where the summed value (Y + Z) is displayed.
Zero-setting
• The zero-setting operation for the Z-axis cannot be performed. The buzzer sounds
twice if the Z-axis zero-set key is pressed.
• If the Y-axis zero-setting operation is performed, the summed value (Y + Z) displayed
on the Y-axis display will be zero-set.
Zero approach machining
• Zero approach data cannot be set for the Z-axis.
• If Y-axis zero approach data is entered, zero approach calculation will be performed
for the Y-axis where the summed value (Y + Z) is displayed.
Bolt-hole circle machining
• The bolt-hole circle machining function cannot be used in the addition mode. The
buzzer sounds twice if the Bolt-hole circle key is pressed.
Display-halving (1/2) function
• The display-halving (1/2) function cannot be performed for the Z-axis.
• If the Y-axis display-halving (1/2) operation is performed, display-halving calculation
will be performed for the Y-axis where the summed value (Y + Z) is displayed.
No. 99MBE032A
3-27
