A SERVICE OF

logo

Step 1 Check that the counter is set to the ABS coordinate in the count mode. If it is not
set to the ABS coordinate, press the key to switch to the ABS coordinate.
After confirming the display, press the key twice.
(Press twice)
“t” on the sub-display blinks to indicate that the counter is in the tool offset setup
mode.
NOTE
If the current coordinate is the ABS coordinate, the decimal point in the sub-display is
illuminating.
For more information about the ABS coordinate, refer to “3.3.8 A/I coordinate switch”.
Step 2 To change the tool number, press a numeric key corresponding to the tool
number assigned to the tool used. Specify the tool number 1 by pressing the 1
key. The tool number 1 will be displayed.
No. 99MBE032A
3-30