A SERVICE OF

logo

Open as PDF
next previous
4. PARAMETERS
• Set the number of axes to 1.
Step 1 Turn the main power switch (rear panel) on while pressing the Load key, and
active the parameter setting mode.
If the parameter setting mode is already activated, this step can be omitted.
Step 2 Set Parameter 13 (Number of axes).
Step 3 Designate the X-axis and set setup data 0 (1-axis specification).
NOTE
When you continue the entry of other parameters, return to step 2 after completing step
3.
Step 4 Press the Cancel key to exit from the parameter setting mode.
No. 99MBE032A
4-17