Filter
Top Products
Settings
101
Sleep mode—Select whether the display is switched off to
save battery power. If the screen saver is turned off, the
cover display switches off after 1 minute. If the screen
saver is turned on, the cover display switches off at the end
of the screen saver period (1-15 minutes).
Call config.
Send my caller ID—To set your phone number to be
displayed or hidden from the person to whom you are
calling, select Yes or No. The value may be set by your
network operator or service provider when you make a
subscription (Set by network) (network service).
Call waiting—Activate this setting if you want the network
to notify you of a new incoming call while you have a call
in progress. To set the function on or off, select Activate
or Cancel. To check whether the function is activated,
select Check status.
Reject call with SMS—Select Yes to send a text message
to a caller informing why you could not answer the call.
See "Answer or decline a call," p. 74.
Message text—Write a text to be sent in a text message
when you decline a call.
Automatic redial—Select On, and your device makes a
maximum of 10 attempts to connect the call after an
unsuccessful call attempt. To stop automatic redialing,
press .
Summary after call—Activate this setting if you want the
device to briefly display the approximate duration of the
last call.
1-touch dialing—Select On. To dial the numbers assigned
to the speed dialing keys ( — ), press and hold the
key. See also "1-touch dial a phone number," p. 73.
Anykey answer—Select On. To answer an incoming call,
briefly press any key, except , , , and .
Line in use—This setting (network service) is shown only
if the SmartChip card supports two subscriber numbers,
that is, two phone lines. Select which phone line you want
to use for making calls and sending text messages. Calls
on both lines can be answered irrespective of the selected
line. If you select Line 2 and have not subscribed to this
network service, you will not be able to make calls. When
line 2 is selected, is shown in the idle mode.
Tip! To switch between the phone lines, press and
hold in the idle mode.
Line change—To prevent line selection (network service),
select Disable if supported by your SmartChip card. To
change this setting, you need the PIN2 code.
R1114_en.book Page 101 Thursday, October 19, 2006 3:43 PM