Filter
Top Products
Settings
113
features, increase the demand on battery power and
reduce the battery life.
When the device is locked, you cannot use Bluetooth
connectivity. See "Security," p. 104 for more information
on locking the device.
Settings
Press , and select Settings > Bluetooth. When you
open the application for the first time, you are asked to
define a name for your device. After you set Bluetooth
connectivity on and change My phone's visibility to
Shown to all, your device and this name can be seen by
other users with devices using Bluetooth wireless
technology.
Select from the following:
Bluetooth—Select On or Off. To connect wirelessly to
another compatible device, set Bluetooth connectivity On,
then establish a connection.
My phone's visibility—To allow your device to be found by
other devices with Bluetooth wireless technology, select
Shown to all. To hide it from other devices, select Hidden.
My phone's name—Edit the name of your device.
Remote SChip mode—To enable another device, such as a
compatible car kit enhancement, to use the SmartChip in
your device to connect to the network, select On.
Remote SmartChip mode
To use the remote SmartChip mode with a compatible car
kit enhancement, set Bluetooth connectivity on, and
enable the use of the remote SmartChip mode with your
device. Before the mode can be activated, the two devices
must be paired and the pairing initiated from the other
device. When pairing, use a 16-digit passcode, and set the
other device as authorized. See "Pair devices," p. 114.
Activate the remote SmartChip mode from the other
device.
When remote SmartChip mode is on in your device,
Remote SChip is displayed in the idle mode. The
connection to the wireless network is turned off, as
indicated by in the signal strength indicator area, and
you cannot use SmartChip services or features requiring
cellular network coverage.
When the wireless device is in the remote SmartChip
mode, you can only use a compatible connected
enhancement, such as a car kit, to make or receive calls.
Your wireless device will not make any calls, except to the
emergency numbers programmed into your device, while
in this mode. To make calls from your device, you must
first leave the remote SmartChip mode. If the device has
been locked, enter the code to unlock it first.
To leave the remote SmartChip mode, press the power key,
and select Exit rem. SChip mode.
R1114_en.book Page 113 Thursday, October 19, 2006 3:43 PM