Filter
Top Products
Tools
88
Automatic redial—Select On, and your phone makes a
maximum of ten attempts to connect the call after an
unsuccessful call attempt. To stop automatic redialling
press .
Summary after call—Activate this setting if you want the
phone to briefly display the approximate duration of the
last call.
Speed dialling—Select On, and the numbers assigned to
the speed dialling keys ( - ) can be
dialled by pressing and holding the key. See also ‘Speed
dial a phone number’, p. 21.
Anykey answer—Select On, and you can answer an
incoming call by briefly pressing any key, except ,
, , and .
Line in use (network service)—This setting is shown only
if the SIM card supports two subscriber numbers, that is,
two phone lines. Select which phone line you want to use
for making calls and sending text messages. Calls on both
lines can be answered irrespective of the selected line. If
you select Line 2 and have not subscribed to this network
service, you will not be able to make calls. When line 2 is
selected, is shown in the standby mode.
Tip! To switch between the phone lines, press and
hold in the standby mode.
Line change (network service)—To prevent line selection,
select Line change > Disable if supported by your SIM
card. To change this setting, you need the PIN2 code.
Connection settings
Data connections and access points
Your phone supports packet data connections ( ), such as
GPRS in the GSM network.
Glossary: General packet radio service (GPRS) uses
packet data technology where information is sent in
short packets of data over the mobile network.
To establish a data connection, an access point is required.
You can define different kinds of access points, such as:
• MMS access point to send and receive multimedia
messages
• Access point for the Web application to view WML or
XHTML pages
• Internet access point (IAP) to send and receive e-mail
Check the kind of an access point you need with your
service provider for the service you wish to access. For
availability and subscription to packet data connection
services, contact your network operator or service provider.
R1105_en.book Page 88 Monday, February 7, 2005 1:31 PM