Nokia 6680 Cell Phone User Manual


 
Tools
90
To be able to use a data connection, the network service
provider must support this feature, and if necessary,
activate it for your SIM card.
Access point name (for packet data only)—The access
point name is needed to establish a connection to the
packet data and UMTS networks. You obtain the access
point name from your network operator or service
provider.
Tip! See also ‘Receive MMS and e-mail settings’, p.
47, ‘E-mail’, p. 54, and ‘Access the Web’, p. 60.
User name—The user name may be needed to make a data
connection, and is usually provided by the service
provider. The user name is often case-sensitive.
Prompt password—If you must enter a new password
every time you log in to a server, or if you do not want to
save your password in the phone, choose Yes.
Password—A password may be needed to make a data
connection, and is usually provided by the service
provider. The password is often case-sensitive.
Authentication—Select Normal or Secure.
Homepage—Depending on what you are setting up, write
the Web address or the address of the multimedia
messaging centre.
Select Options > Advanced settings to change the
following settings:
Network type—Select the Internet protocol type to use:
IPv4 settings or IPv6 settings.
Phone IP address—Enter the IP address of your phone.
Name servers—In Primary name server:, enter the IP address
of the primary DNS server. In Second. name server:, enter
the IP address of the secondary DNS server. Contact your
Internet service provider to obtain these addresses.
Glossary: The domain name service (DNS) is an
Internet service that translates domain names such as
www.nokia.com
into IP addresses like 192.100.124.195.
Proxy serv. address—Define the address for the proxy
server.
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data conn.—If you select When available and you
are in a network that supports packet data, the phone
registers to the packet data network. Also, starting an
active packet data connection is quicker (for example, to
send and receive e-mail). If you select When needed, the
phone uses a packet data connection only if you start an
application or action that needs it. If there is no packet
data coverage and you select When available, the phone
periodically tries to establish a packet data connection.
R1105_en.book Page 90 Monday, February 7, 2005 1:31 PM