Copyright © 2002 Nokia. All rights reserved.
Your phone
19
Transfer is used to connect an incoming call or a call on hold with an active call and to
disconnect yourself from both calls.
Send DTMF is used to send DTMF tone strings, for example, passwords or bank account
numbers.
Glossary: DTMF tones are the tones you hear when you press the number keys on
the phone keypad. DTMF tones allow you to communicate with voice mailboxes and
computerised telephony systems, for example.
1 Key in the digits with - . Each keystroke generates a DTMF tone, which
is transmitted while the call is active. Press repeatedly to produce: *, p (inserts
a pause of approx. two seconds before, or between DTMF characters.), and w (if you use
this character, the remaining sequence is not sent until you press Send again during
the call). Press to produce #.
2 To send the tone, press OK.
Tip! You can also store a sequence of DTMF tones for a contact card. When you
make a call to the contact, you can retrieve the sequence. Add DTMF tones to the
phone number or DTMF fields in a contact card.
Settings for call diverting
Go to Menu→
Tools→ Call divert.
When this network service is activated, you can direct your incoming calls to another
number, for example, to your voice mailbox number. For details, contact your service
provider.
• Select one of the divert options, for example, select If busy to divert voice calls when
your number is busy or when you reject incoming calls.
• Select Options→ Activate to set the divert setting on, Cancel to set the divert setting
off, or Check status to check whether the divert is activated or not.
• To cancel all active diverts, select Options→ Cancel all diverts.
For information about the divert indicators, see ‘Indicators related to actions’, p. 8
.
Fig. 3 Options during a
call.
