Filter
Top Products
Prior Settings
Item Description/Setting
DHCP server option 66 192.168.0.130
IP address range assigned by DHCP server 192.168.0.16 to 192.168.0.63
File name of the configuration file used for
pre-provisioning
KX-TGP500B01.cfg
URL of the configuration file used for
provisioning that is entered in the configuration
file
CFG_STANDARD_FILE_PATH="http://
provisioning.example.com/Panasonic/
Config{MAC}.cfg"
Note
• "{MAC}" is replaced by the MAC address of the
unit.
(e.g., "0080F0123456")
Stored location of the configuration file on the
TFTP server
Configuration file "KX-TGP500B01.cfg" is stored in the
directory "/tftproot".
To set up the server for pre-provisioning
1. Start up the DHCP server and TFTP server, and configure the settings as specified above.
2. Connect the unit to the network, and turn the power on.
a. The IP address "192.168.0.16" is assigned to the unit by the DHCP server.
b. The unit acquires the TFTP server address "192.168.0.130" from the DHCP server using DHCP server
option 66.
c. The unit downloads the configuration file for pre-provisioning from the TFTP server:
tftp://192.168.0.130/KX-TGP500B01.cfg
d. The URL of the server where the configuration file for provisioning is stored (provisioning server) is set
to the unit:
http://provisioning.example.com/Panasonic/Config{MAC}.cfg
e. When pre-provisioning has completed successfully, the status LED lights in the following order:
Red ® Green ® Orange ® Red ® …
3. When the status LED lights as described in step e, turn off the unit’s power.
When the unit is distributed to end users and started up in real circumstances, provisioning will be
performed correctly.
Note
• This example describes the case when only one unit is connected. However, multiple units can be
configured through the same procedure without changing any settings, because the MAC address is
specified by the {MAC} macro.
20 Administrator Guide Document Version 2010.03.15
1.1.5 Pre-provisioning