Filter
Top Products
1.1.8 Phone User Interface Programming
You can change the settings directly from the unit.
For details about the operations, refer to the User Guide on the Panasonic Web site (® see Introduction).
For details about additional features available with direct commands, see Section 2 Phone User Interface
Programming.
1.1.8.1 Changing the Language for Phone User Interface Programming
You can change the language used on the LCD. Because the language settings for the LCD of the base unit
and handsets are not synchronized, you must set the languages individually for the base unit and each handset.
The available languages may differ depending on the country/area of use.
For details about changing the setting, refer to the User Guide on the Panasonic Web site (® see
Introduction).
1.1.9 Priority of Setting Methods
The same settings can be configured by different configuration methods: provisioning, Web user interface
programming, etc. This section explains which value is applied when the same setting is specified by multiple
methods.
The following table shows the priority with which settings from each method are applied (lower numbers indicate
higher priority):
Setting Order
Priority Setting Method
1 4 The factory default settings for the unit
2 3 Pre-provisioning with the configuration file
3
2–3 Provisioning with the master configuration file
2–2 Provisioning with the product configuration file
2–1 Provisioning with the standard configuration file
4 1
Settings configured from the Web user interface or the phone user
interface
According to the table, settings configured later override previous settings (i.e., settings listed lower in the table
have a higher priority).
If different values are specified for the same setting by the master configuration file and Web user interface
programming, the value specified from the Web user interface is applied. This is because values specified from
the Web user interface have a higher priority.
For settings configured from the Web user interface and the phone user interface, the value specified most
recently receives priority.
1.1.10 Other Network Settings
1.1.10.1 Firewall and Router Setup
When the unit is connected to a network that is protected by a firewall and/or router, you need to configure the
firewall and/or router so that they do not block communication from the IP address and port number used by
the unit.
28 Administrator Guide Document Version 2010.03.15
1.1.10 Other Network Settings