63
Main Menu
Differential Field
Differential receiver status is indicated in the bottom left fi eld of the page and will show one of the
following conditions:
• None: No optional beacon receiver is attached or enabled in the Comm tab (Main Menu) or
WAAS is turned Off.
• Searching for WAAS: WAAS is enabled and the receiver is searching for WAAS signal.
• Using WAAS: WAAS capability is enabled and the unit is receiving WAAS corrections.
• Check Beacon Wiring: The DGPS setting is enabled in the Comm tab (Main Menu) but no DGPS
device is detected.
• No Beacon Signal: DGPS receiver is attached, but not transmitting RTCM data to GPS.
• Tuning Beacon: Receiver is tuning manual DGPS frequency.
• Using Differential: Unit is receiving DGPS corrections.
• Scanning for Beacon: DGPS receiver is scanning for available frequency.
GPS Tab Options Menu
When the GPS Tab is open, press the MENU key to open the GPS Tab Options Menu:
Start/Stop Simulator – activates and deactivates simulator mode, which is particularly helpful when
learning how to use your unit.
WAAS On – enables WAAS capability. Refer to the Appendix for more information about WAAS.
Track Up Skyview/ North Up Skyview – orients the skyview display between a north up or track up
for the GPS Tab only.
New Altitude – allows you to manually enter your altitude.
New Location – allows you to enter a new location automatically or using the map.
GPS Tab
Main Menu: GPS Tab
Differential Status
GPS Tab Options Menu
190-00335-00_0A.indd 63 4/7/2004, 1:50:55 PM
