Filter
Top Products
Installing Switch Cards
Issue 1 October 1998
4-3
DIP
Switch
Settings
Each Switch Card is equipped with a four position DIP switch,
all of which should remain in the OFF position.
Note: If they are NOT all OFF, your Switch Card will not
function properly.
How to Install Switch Cards in the Rack
Procedure
1. Carefully slide the card into the chosen slot in the Rack. (see Figure 4.1)
Note: Component side of the card (the side where the LED is mounted)
should face the power supply of the Rack.
Figure 4.1. Sliding the Switch Card in the Rack.
2. Push the card until it is completely seated in the connector.
3. Configure and update the new card. (see page 5-13)
4. Change the administrator password through the Switch Management
Interface or Terminal Emulation. (see page 5-15)