Filter
Top Products
Configuration
5-6 Issue 1 October 1998
How to install the Switch Management Interface
Note: The Switch Management Interface software must be installed before
the ADMIN port can be used to configure Switch Cards.
The Switch Management Interface is compatible with Windows 95 and
Windows NT 4.0. The software is provided on two floppy diskettes.
Installation uses the standard Windows 95 install wizard to create a Switch
Management Interface program group in Windows.
Procedure
Important: Close all open applications before installing.
1. Insert disk 1 of 2 into the floppy drive.
2. Click Start: Run.
3. Enter the program setup file: a:\setup.exe. Click OK. (see Figure 5.2
below)
Figure 5.2. Select floppy drive
4. The Switch Management Interface setup prepares the install wizard for
installation.