Lucent Technologies 3100 Carrying Case User Manual


 
Configuration
Issue 1 October 1998
5-13
Initial Card Detection
Introduction
Displaying
Information
Once a password file has been created or opened, the
software automatically connects to the Rack and detects the
Switch Cards that are installed.
Note: If the Switch Cards are not being detected, check your
PC COM port, RS-232 cable, and communication settings
within the Switch Management Interface. (see page 5-30)
To view information for a specific card, click on the card
shown under the Hardware tab (see Figure 5.7 below).
Important: For displaying cards that have been recently
added or “Hot swapped”, press “Disconnect” then
“Connect”.
Figure 5.7. Initial card detection screen