Filter
Top Products
120
01
02
03
04
05
06
07
08
121
SAR INFORMATION
THIS MODEL PHONE MEETS THE GOVERNMENT’S
REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your wireless phone is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to radiofrequency
(RF) energy set by the Federal Communications Commission of the U.S.
Gove
rnment. These limits are part of comprehensiv e guidelines and establish
permitted levels of RF energy for the general population. The guidelines ar e
based on standards that were developed by independent scientific or ganizations
through perio
dic and thorough evaluation of scientific studies. The standards
include a substantial safety margin designed to assure the safety of all persons,
regardless of age and health.
The exposure standar d for wir eless mobile pho
nes employs a unit of
measurement known as the Specific Absorption Rate, or SAR. The SAR limit set
by the FCC is 1.6 W/kg. * Tests for SAR are conduct ed with the phone tr ansmitting
at its highest certified power level in all tested fr
equency bands. Although the
SAR is determined at the highest certified power level, the actual SAR level of the
phone while operating can be well below the maximum value. This is because the
phone is designed to operate at m
ultiple power levels so as to use only the power
required to reach the network. In general, the closer you are to a wireless base
station antenna, the lower the power output.
Before a phone model is
available for sale to the public, it must be tested
and certified to the FCC that it does not exceed the limit established by the
government adopted requirement for safe exposure. The tests ar e performed in
p
ositions and locations (e.g., at the ear and worn on the body) as required by the
FCC for each model.
The highest SAR value for this model phone when tested for use at the ear is
1.25 W/Kg and when worn on the body, as described in this user guide,
is
0.61 W/Kg. (Body-worn measurements differ among phone models, depending
upon available accessories and FCC requirements). While there may be differences
between the SAR levels of various phones and at v arious positions, they all meet
the gov ernment requirement for safe exposure.
The SAR testing for Body-worn operation was performed with a belt clip that
provided a 2.0 cm separation. The User’s Manual indica tes that any holsters/clips
used with
this device should contain no metallic components.
The FCC has granted an Equipment Authorization for this model phone with
all reported SAR levels evaluated as in compliance with the FCC RF exposure
guidelines.
SAR information on t
his model phone is on file with the FCC and can be found
under the Display Grant section of
http://www.fcc .go v/oet/ea
after searching
on JYCJ_TOUCH.
Additional information on Specific Absorption Rates (SAR) can be found on the
Cellular Telecommunications Industry Association (CTIA) web-site at
http://www.ctia.org
.
* In the United States and Canada, the SAR limit for mobile phones used by the
public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The standard
incorporates a substantial margin of safety to giv e additional protection for the
public
and to account for any variations in measurements.