Filter
Top Products
116 SAMSUNG SPS1000
FUNCTION KEY - DEFINITIONS
NEXT RECORD
Used to program the next record key, used during programming to move through the program records.
#/NOSALE
Used to enter a non-adding memo number during a transaction, or used to open the cash drawer outside of a sale
HALO DIGITS FOR NON-ADD ENTRY This is the maximum digits for the reference number.
ALLOW NOSALE FUNCTION This will enable the operator to open the cash drawer
ALLOW NON-ADD FUNCTION This will enable the operator to enter a reference number
NOSALE IN X ONLY This forces the use of X Manager Mode for this key
NOSALE INACTIVE AFTER Once a reference has been entered it its not
NON-ADD ENTRY possible to continue by just opening the drawer, a sale is required.
COMPULSORY VALID ON NOSALE This forces validation if a cancel is done (only on valid printers)
ENFORCE NON-ADD AT This forces the operator to enter a reference number before
BEGINNING OF SALE commencing a sale
COMP. NON-ADD# MUST MATCH The halo is no longer a maximum but a compulsory criteria
HALO DIGIT# i.e. 6 becomes not digit 1 to 6 but fixed to 6 digits
P/BAL
Enter an amount, then press the manual previous balance (P/bal) key to use the simplest form of charge posting /
Table Service. The P/bal key may be used any time, within a transaction. Transactions where the P/Bal key is
used must be finalised with the service key
MUST BE ENTERED AT START OF SALE This forces an opening balance at start of a sale
COMPULSORY P/BAL This forces an entry of balance during a sale.
PAGE DOWN
This key switches between pages on the register display. Used in Window Look Ups etc.
PAGE UP
This key switches between pages on the register display. Used in Window Look Ups etc.
PAID OUT 1 - 5
Press a Paid Out key to remove moneys from the drawer
HALO (0:NO LIMIT) This is the maximum sale amount for this key
ACTIVE IN X ONLY This forces the use of X Manager Mode for this key
COMPULSORY VALIDATION This forces validation on this key (only on valid printers)
PAID RECALL
The paid recall key is used to recall the last number of transactions, where the number of transaction is
determined in the memory allocation. The RECEIPT key can be used to issue copy receipt of past transactions.
ACTIVE IN X ONLY This forces the use of X Manager Mode for this key
FUNCTION KEY - DEFINITIONS