Filter
Top Products
85 SAMSUNG SPS1000
ROM FILE DOWNLOAD
This is used to transmit a PC downloaded flash ROM from the master terminal to the slaves within the system.
(see the technical appendix for the PC ROM download procedure)
CAUTION: After completing this section you must then reset all programmed
information, back to the factory default settings using the program reset
procedure
This will erase the existing ROM and transmit a new flash ROM (which has been download from the P.C.) down
the IRC network, Please consult the technical appendix for P.C. Flash ROM download procedures to tranmsit the
rom from the P.C. When the ROM is transmitted only those set to receive will be amended, this will have no
effect on any machines in the system not set.
TO PREPARE RECEIVING TERMINALS
1. Turn the power switch located on the right side of the register to
the
OFF
position.
2. Turn the key lock to the
S-MODE
position (one position clockwise
from the
PGM
key lock position).
3. Press and hold the key position where the
CASH
key is located on
the default keyboard layout.
4.
Continue to hold the
CASH
key whilst turning the power switch to
the
ON
position.
(see figure 1)
5. Press each of the four corner keys
TOP LEFT, BOTTOM LEFT, TOP RIGHT, BOTTOM RIGHT
(see
figure 2)
6. The screen will say download and is now waiting for the download
procedure to be activated on the transmitting terminal.
NOTE: Please carry out an initial all program clear after
transmitting the ROM
Figure 1.
1st
Figure 2.
3rd
1
SUB-
TOTL
32
4
CHEQUE
65
7
MISC
TEND1
98
0
CASH
.
00
2nd
4th
Press and hold
this key position
during power-up
in S-MODE
Press each
of the four
corner keys
in turn