Filter
Top Products
● Prompt password — If you must enter the
password every time you log in to a server, or if
you do not want to save your password in the
device, select Yes.
● Password — A password may be needed to
make a data connection and is usually provided
by the service provider.
● Authentication — Select Secure to always send
your password encrypted or Normal to send
your password encrypted when possible.
● Homepage — Depending on the access point
you are setting up, enter the web address or the
address of the multimedia messaging centre.
Select Options > Advanced settings to change
the following settings:
● Network type — Select the internet protocol
type to transfer data to and from your device. The
other settings depend on the selected network
type.
● Phone IP address (for IPV4 only) — Enter the IP
address of your device.
● DNS address — Enter the IP addresses of the
primary and secondary DNS servers, if required
by your service provider. Contact your internet
service provider to obtain these addresses.
● Proxy server address — Enter the address of
the proxy server.
● Proxy port number — Enter the port number
of the proxy server.
WLAN internet access points
Press , and select Tools > Settings >
Connection > Access points > Options > Edit
or New access point.
Follow the instructions from the WLAN service
provider.
● WLAN network name — Select Enter
manually or Search for networks. If you select
an existing network, WLAN network mode and
WLAN security mode are determined by the
settings of its access point device.
● Network status — Define whether the network
name is displayed.
● WLAN network mode — Select Ad-hoc to
create an ad hoc network and to allow devices to
send and receive data directly; a WLAN access
point device is not needed. In an ad hoc network,
all devices must use the same WLAN network
name.
● WLAN security mode — Select the encryption
used: WEP, 802.1x (not for ad hoc networks), or
WPA/WPA2. If you select Open network, no
encryption is used. The WEP, 802.1x, and WPA
functions can be used only if the network
supports them.
To enter the settings for the selected security mode,
select WLAN security settings.
Security settings for WEP
152
Settings