Set the offset value at the specified memory location in
dBm.
Syntax:
MOF<mem><;><value>
mem:
Memory location 1 to 30.
value:
Offset value in dBm.
Remarks:
Set the offset value at memory store address <mem> to <value> dBm
MRF Set the reference value at the specified memory location in
dBm.
Syntax:
MRF<mem><;><value>
mem:
Memory location 1 to 30.
value:
Reference value in dBm.
Remarks:
Set the reference value at memory store address <mem> to <value> dBm.
ODT Output the current calibration factor, offset value, and refer-
ence level.
Remarks:
These are output as three separate messages in the output buffer, as
shown below:
CAL factor: 18 ASCII characters + <CR><LF>
OFFSET value: 18 ASCII characters + <CR><LF>
REFERENCE level: 19 ASCII characters + <CR><LF>
NOTE
When the ODT, OMR, and OPW data output commands
are received simultaneously, only the command which is
received last is valid.
ML2430A OM 6-89
GPIB OPERATION ML4803A EMULATION COMMANDS
<CR><LF>
<CR><LF>
<CR><LF>
CAL
OFFSET
REFERENCE
dB
dB
dBm
.
.
.
5 CHARACTER DATA
5
5
1
Figure 6-3. ODT Data Output Format
