Filter
Top Products
6 - 2
BattMon
BattMon programs the terminal’s LEDs to monitor the charge status of the battery.The LEDs are located
on the front panel of Dolphin terminals.
To Enable BattMon
1. Tap Start > Power Tools. The Dolphin Power Tools Main Window (see page 1-2) appears.
2. Tap the BattMon icon once . After activation, BattMon monitors the battery’s charge status.
When the battery is at 100%, the green LED lights solid green.
When the battery is charging the green LED flashes.
Note: To start BattMon automatically after each hard reset, enable the BattMon Program section of the
Autorun.exm File (see page 4-1).
To Disable BattMon
Navigate to the Dolphin Power Tools Main Window (see page 1-2) and tap the BattMon icon again.
OR
Select Exit on the Command Bar Menu (page 6-2).
Command Bar Menu
When BattMon is enabled, a smaller BattMon icon appears in the Command bar at the bottom of the
Today screen.
Tap this icon to open the Command bar menu.
Menu Item This item …
Status Displays the battery charge status in percentage.