Filter
Top Products
5 - 7
Powerout Enables and disables power out of the
serial port for ScanWedge specifically.
General power out settings are
established in the registry.
The serial port powers out 5V at
500mA.
This parameter is supported for all
software configurations of the Dolphin
7900 and for the following software
configurations of the Dolphin 9500:
• Kernel 7.01, SP8 or later
• Kernel 7.03, SP1 or later (Kernel 7.03
alone is not supported.)
0
0=Disabled; do not power out when
scanning with ScanWedge
1=Enabled; power out when scanning
with ScanWedge.
2=No change for ScanWedge. This
means that ScanWedge is not altering
the default power out setting in the
registry. The terminal defaults to the
power-out setting in the registry.
EnablePrefixData Enables or disables all prefix data
received via COM port after a
successful scan.
All prefix data is defined in the Settings
Section (see page 5-3).
0
0=Disabled
1=Enabled
EnableSuffixData Enables or disables all suffix data
received via COM port after a
successful scan.
All suffix data is defined in the Settings
Section (see page 5-3).
0
0=Disabled
1=Enabled
Comm Section
The serial port settings in the Comm section determine the interaction between ScanWedge and the serial
port.
Comm Section
Key
Description Default
Value
Available Values