Filter
Top Products
3 - 7
NetworkType Determines the type of network the radio
should access.
1
0=AdHoc (Minimum)
1=Infrastructure
2=Pseudo-AdHoc
TxRate Defines the transmit rate. 15
1=1 Mb (Minimum)
2=2 Mb
3=Auto 1/2 Mb
4=5.5 Mb
8=11 Mb
15=Fully Auto (Maximum)
Channel Channel (1-11) of the RF adapter.
In general, this parameter is used only in
AdHoc network mode.
10
1=Minimum
11=Maximum
APSearchThre
shold
Specifies how easily the radio switches
from the current access point to a new
one in a roaming network. Selecting
Low, Medium, or High depends on how
close the coverage areas or the access
points are in your installation.
Low
Density
Low Density=Select if your installation
consists of access points with little
overlap in their coverage areas to make
the radio switch faster before its signal
becomes too low.
Medium Density=Select if your installation
consists of access points with medium
overlap in their coverage areas.
High Density=Select if your installation
consists of access points with high
overlap in their coverage areas to
prevent the radio from switching too
often.
Encryption Specifies the encryption method. 0
0=No Encryption
1=WEP 64-bit RC4 encryption
2=WEP 128-bit RC4 encryption
Authentication Specifies the authentication mode. 0
0=Open; WEP keys are not used
1=Shared; WEP keys are used
2=Automatic; auto-discriminates between
Open and Shared authentication
modes
Active Key Specifies the key to use to encrypt
transmitted data.
Note: These keys are used only if 1 or 2
is selected as the Encryption
method.
0
1=Key1 key
2=Key2 key
3=Key3 key
4=Key4 key
Key1–4 Defines keys 1–4.
Note: The keys in this section are
encrypted; see Encrypted on page
2-13. EZConfig Editor and
EZConfig Client both support
encryption
.
None
ASCII–Use quotes for the value; e.g.,
"hello")
Hex–Type the pair of hex values in a row;
e.g., AFB0FF415A
64-bit encryption–Length must be 5
characters or 5 hex pairs
128-bit encryption–Length must be 13
characters or 13 hex pairs
NonSupplicant Section–Dolphins 7900 and 9500
Key Description Defaul
t Value
Available Values