Filter
Top Products
5 - 5
SendMode Specifies the method to use when sending
the decoded message to the foreground
application.
Note: This setting affects only the decoded
message; the prefix and suffix are
always sent using the virtual key
method to allow navigational
functionality.
Note: This key does not appear in the
ScanWedge.exm file for the Dolphin
6100/6500/7600.
0
0=Virtual key method: each
character is sent as a virtual
keystroke. This method works
well with almost any Windows
Mobile or Windows CE
application.
1=Direct Text method: the decoded
message is sent as text directly
to the window that has the
keyboard focus in the foreground
application. This method is faster
than the virtual key and supports
barcodes with ASCII characters
between 1 and 255 but works
only if the foreground application
uses standard Window’s Edit
controls for user input.
2=Virtual Key (safe) method: each
character is sent as a virtual
keystroke using
PostKeybdMessage().
This method only support bar
codes containing ASCII
characters and does not support
VKMapping. This method only
generates WM_CHAR
messages, it does not generate
WM_KEYDOWN and
WM_KEYUP messages.
GoodScanWav Specifies a .wav file played on the
completion of a successful decode/data
reception.
Empty
Empty=No .wav file is specified.
The default beep or sound is
played. Use the Sound (page 5-
3) key to enable and disable all
audio notification.
X=The path to the specific .wav file
you want played for either option.
The .wav files should be 8-bit,
11KHz, mono, and PCM.
BadScanWav Specifies a .wav file played for an
unsuccessful decode/data reception.
Empty
Settings Section
The Settings section determines how ScanWedge interprets data from the decoder, serial port, and IrDA
interface.
0 = Disable 1 = Enable
Settings Section
Key
Description
Default
Value
Available Values