Filter
Top Products
6 - 12
RASMan Configuration File
RASMan application settings are stored in the Settings section of \IPSM\RASMan.exm. Use EZConfig Editor
(see page 2-2) to change the values in the RASMan.exm file.
Key Description
Default
Value
Available Values
AudioNotification Enable and disable audio
notifications on connecting and
disconnecting.
1
0=Disable
1=Enable
AutoConnectOnDock Connects and disconnects RASMan
when the terminal is docked and
removed from the communication
peripheral.
1
0=Disabled; RASMan connection
must be launched manually when
the terminal is docked.
1=RASMan connects on an AC
power event.
2=RASMan connects on RS-232/
USB connection.
AutoConnectOnStart
up
Controls the automatic connection
when RASMan is started.
RASMan attempts to connect only if
the device is docked and AC power
is detected.
1
0=Disabled; the PPP connection is
not established when RASMan is
started.
1=Enabled; the PPP connection is
established when RASMAN is
started.
Connectoid
Indicates the connection RASMan
should use.
`USB
Connectio
n
`USB Connection
`115200 Default
`19200 Default
`38400 Default
`57600 Default
These values must be typed in
exactly as they appear here.
CommandLine
Command to execute on a
successful connection.
Empty
Leave empty if no action is required.
CommandArgs
Command arguments for the
CommandLine setting.
Empty
Leave empty if no action is required.
ConnectDelay Specifies the amount of time to wait
before establishing the PPP
connection after RASMan is
started.
2000
Enter values in milliseconds.
Debug Enables and disables the creation
of a debug log file.
0
0=Disabled; no log file
1=Enabled; Creates a log file of
RASMan activity in the \IPSM
folder.
DisableActiveSync Disables the ActiveSync connection
when RASMan is running.
1
0=Disabled; ActiveSync runs while
RASMan is running.
1=Enabled; the ActiveSync
connection is disabled while
RASMan is running.