Filter
Top Products
4 - 3
Programs’ Subsections—Dolphins 7850, 7900, & 9500
Here are a few of the standard child sections of the Programs section:
Note: Other subsections launch the executable entered in the Program (see page 4-3) key.
Keys in Each Programs’ Subsection—Dolphins 6100, 6500, 7600, 7850, 7900, & 9500
Each Programs’ subsection contains or can contain the following keys:
StartMenu Enables and disables the Start menu during
Autorun
1
0=Disable; the Start menu
is disabled during
Autorun.
1=Enable; the Start menu
is enabled.
Debug Controls the debug function at AutoInstall.
00=Disable
1=Enable, an autorun.log
file is created in the
\IPSM
(\Honeywell
for 6100/6500)
folder.
TestMode Runs the terminal in test mode and tests the
functionality of AutoInstall. This is a diagnostic tool.
When enabled, applications stored in the
AutoInstall folder, including the radio drivers, are
not loaded during startup.
00=Disable
1=Enable
MaskPassword If a password is entered in the Password key, this
key determines if that password is masked when
entered on the screen.
10=Disable
1=Enable
Section Description
Update Attempts to launch an Update.exe application from the SD (Secure Digital) card, if one exists.
AutoRun
SC1 & SC2
Attempts to process an Autorun configuration file from the SD card (if one exists); for example,
to install CAB files from the AutoInstall folder in the SD card. One section applies to cold boots
and the other to warm boots.
Reset Initiates a warm boot after the cold boot during startup. Do NOT disable the Reset section!
Key Function
Required Keys—These keys must be present in each Program subsection.
Program Specifies the command line to execute. This is the location of the program’s
executable. If you want a Power Tool to launch at startup, enter the location of that
tool’s EXE here.
Args Specifies the command line arguments to execute at startup.
Key Function Default Available Values