Filter
Top Products
Chapter 2 - Getting started 2-3
SIM card contents
Normally, a new SIM card will not contain any
contact information. After the personalization
procedure, if the SIM does contain stored names
or numbers, you will be asked if you want to
copy the SIM card contents into the communi-
cator’s memory. If the phone interface is
switched off, the question will be asked the next
time the phone interface is on and you activate
the communicator interface.
If you do not want to copy this information, or
want to do so at a later time, answer no. You
may copy information between SIM and phone
memory locations via the phone interface.
Note: All phone numbers copied from the SIM
memory to phone memory will go to the
Tel field of the contact cards. To send SMS
messages, the recipient’s phone number
must be in the Tel (GSM) field. Be sure all
GSM numbers are in the Tel (GSM) field.
(see Chapter 3 "Contacts: Contact cards -
Customizing contact cards" on page 3-3).
Installing the SIM card
Before installing the SIM card, close the device
cover and switch off the phone (use ):
• Remove the battery: Press the catch (1) at the
bottom of the battery (2) and lift away the
battery (Figure 2-1).
‚ Slide the card into the SIM card slot
(Figure 2-2). Make sure that the metal
contacts of the SIM card are facing down
and the bevelled corner is on the right side.
When the SIM card is properly inserted into the
SIM card slot, the bevelled corner will remain
visible (Figure 2-3).
When you are sure that the SIM card is correctly
installed, replace the battery:
• Insert the battery so that the side with the four
metal connector plates goes in first (Figure 2-4).
‚ Push the battery down towards the catch un-
til it clicks into place. Make sure the battery
is properly installed before switching on the
power.
Figure 2-1: Removing the battery
Figure 2-2: SIM installation
Figure 2-3: Installed SIM card
Figure 2-4: Inserting the battery