Filter
Top Products
2. To increase the background scan time interval,
adjust the time in Scan for networks. To stop
background scans, select Show WLAN
availability > Never.
3. To save your changes, press Back.
When Show WLAN availability is set to
Never, the WLAN availability icon is not shown
in the standby mode. However, you can still
manually scan for available WLAN networks, and
connect to WLAN networks as usual.
Q: How can I save my data before deleting it?
A: To save data, use Nokia Nseries PC Suite to
synchronise with or to make a back-up copy of all
data to a compatible computer. You can also send
data using Bluetooth connectivity to a compatible
device. You can also store data on a compatible
memory card.
Q: What do I do if the memory is full?
A: Delete items from the device memory or mass
memory. If your device displays the note Not
enough memory to perform operation. Delete
some data first. or Memory low. Delete some
data from phone memory. when you are deleting
several items at the same time, delete items one by
one, beginning with the smallest items.
See "Free
memory", p. 23.
Q: Why can’t I select a contact for my
message?
A: The contact card does not have a phone number,
an address, or an e-mail address. Press
, select
Contacts, the relevant contact, and edit the contact
card.
Q: How can I end the data connection when
the device starts a data connection again and
again?
A: The device may be trying to retrieve a multimedia
message from the multimedia message centre. To
stop the device from making a data connection,
press
, and select Messaging > Options >
Settings > Multimedia message > Multimedia
retrieval and Manual to have the multimedia
messaging centre save messages to be retrieved
later, or Off to ignore all incoming multimedia
messages. If you select Manual, you receive a
notification when you have a new message in the
multimedia message centre. If you select Off, the
device does not make any network connections
related to multimedia messaging. To set the device
to use a packet data connection only if you start an
application or action that needs it, press
, and
select Tools > Settings > Connection > Packet
data > Packet data connection > When
needed. If this does not help, switch the device off,
and switch it on again.
177
Troubleshooting