Filter
Top Products
Tools 104
Note:
Speaking clearly, say the command that you want to use. If, after a few
seconds, the device has not recognized a command, it prompts you to
repeat the command. If, after a few more seconds, it still has not
recognized a command, it tells you “Sorry, no match found,” and
cancels voice recognition.
Voice Command Tips:
Make sure you wait for the beep before speaking.
Speak clearly at a normal volume, as if you were talking on the
phone.
Voice-Activating Your Contacts List
When you first start VoiceSignal, it reads your Contacts list and
voice-activates all the names stored there. When you have add or
change contacts, VoiceSignal automatically reloads and voice-
activates the entire list.
Ending Calls Before Restarting the VoiceSignal Software
When you use VoiceSignal to make a call, you must end that call
before you can use VoiceSignal again.
Voice Settings
Choice Lists
VoiceSignal uses choice lists when it is not confident it has
correctly recognized a name or number. In this case, it can
display a list of up to three possible choices, and prompt you to
confirm the correct one.
You can change the way that VoiceSignal uses choice lists with
name dialing, digit dialing, and contacts. For each feature, you
can choose to always see a choice list (even if there is only one
choice), or never see a choice list (even if there are multiple
choices). If you leave the setting at “Automatic,” VoiceSignal
displays a choice list only when it is not confident it has correctly
recognized the name or number.
To change the way VoiceSignal uses choice lists:
1. In standby mode, press the
MENU
key ( ), then press
(for
Tools
), (for
Voice Service
), (for
Voice Settings
), and for
Choice Lists
the following
options appear in the display:
•Automatic
—VoiceSignal displays a choice list only when it is not
sure if it has correctly recognized the name or number.
•Always On
—VoiceSignal always displays a choice list, even when
there is only one choice.
•Always Off
—VoiceSignal never displays a choice list.
Use the navigation keys to highlight the Choice List
behavior you prefer, then press the key to accept the
new setting.