Schneider Electric DS301 Cell Phone User Manual


 
0198441113586, V2.01, 11.2008
IL•1F CANopen DS301 4 Installation
Fieldbus interface 51
4 Installation
For information on installation of the device and connecting the device to
the fieldbus see the product manual.
Slave withDIP switches Before installing the slave in the system, you must set the network ad-
dress and the baud rate via the DIP switches in the connector housing.
See the chapter "Installation" in the product manual for information on
the DIP switch settings.
@ WARNING
LOSS OF CONTROL
The designer of any control scheme must consider the potential
failure modes of control paths and, for certain critical functions,
provide a means to achieve a safe state during and after a path
failure. Examples of critical control functions are EMERGENCY
STOP, overtravel stop, power outage and restart.
Separate or redundant control paths must be provided for critical
functions.
System control paths may include communication links. Consid-
eration must be given to the implication of unanticipated transmis-
sion delays or failures of the link.
Observe the accident prevention regulations and local safety
guidelines.
1)
Each implementation of the product must be individually and thor-
oughly tested for proper operation before being placed into serv-
ice.
Failure to follow these instructions can result in death or serious
injury.
1) For USA: Additional information, refer to NEMA ICS 1.1 (latest edition), Safety
Guidelines for the Application, Installation, and Maintenance of Solid State Control
and to NEMA ICS 7.1 (latest edition), Safety Standards for Construction and
Guide for Selection, Installation for Construction and Operation of Adjustable-
Speed Drive Systems.
@ WARNING
SIGNAL AND DEVICE INTERFERENCE
Signal interference can cause unexpected responses of device.
Install the wiring in accordance with the EMC requirements.
Verify compliance with the EMC requirements.
Failure to follow these instructions can result in death, serious
injury or equipment damage.