HTC RAPH500 Cell Phone User Manual


 
Getting Started  23
1.10 LED Alerts
The buttons below the touch screen and the exterior edge of the Navigation Control which is an LED ring will 
light up in the following situations:
Controls Light Behavior
SEND button Light flashes when there is an incoming call.
END button Light stays solid when there is an incoming call. 
Navigation Control    The LED ring shows a “breathing” white light when the battery is being charged.
   The LED ring shows a solid white light when the battery is fully charged.
   The LED ring flashes a white light once when the battery level is low and reaches down to 
about 10%.
   The top and bottom parts of the LED ring flashes a white light twice when there is a new 
e-mail, voice mail, or meeting reminder.
   A white light goes around the LED ring counterclockwise twice starting from the top when 
there is a missed call or new SMS message.
The LED ring, HOME, BACK, SEND, and END buttons will flash a white light once when one of the buttons or 
Navigation Control is pressed.
1.11 Adjusting the Volume
Adjusting the system volume changes the volume level of sound notifications and audio/video playback, 
whereas adjusting the ring volume affects only the volume of the phone ring. The system volume and ring 
volume can be separately adjusted.
1. Touch the icon area in the title bar and then touch the 
Speaker icon (   ) on the System Status 
screen.
2. To switch between the Ring Volume and System Volume screens, touch Ring or System on top of the 
screen.
3. On either screen, you can do the following:
To increase or decrease the volume level, drag your finger up or down the volume bars. You can also 
press the VOLUME UP/DOWN buttons on the left panel of your device.
Volume bars
Touch Vibrate to switch both System and Ring to Vibrate mode.
Touch 
Silent to mute both the system and ring volume.
4. The System Volume or Ring Volume screen automatically closes. You can also manually close the screen 
by touching the screen.
Note On certain screens that do not show the volume status icon on the title bar, you need to use the VOLUME 
UP/DOWN buttons on the left panel of your device to adjust the volume. Also use these buttons to adjust the 
conversation phone volume during an ongoing call.