Filter
Top Products
PAGE 1
|
INSTALLING THE BATTERY
|
GETTING STARTED
1 GETTING STARTED
Installing the battery
Your Amp’d Mobile
TM
Jet phone comes with a
removable lithium ion (LI Ion) battery. Fully
charge the battery before using the phone.
To install the battery:
1. Hold the phone face
down.
2. Slide the tab at the
bottom of the door up
and remove the
battery door.
3. Place the battery in
the phone casing with
the metal contacts
facing the right side of
the phone.
4. Replace the battery
door by sliding the
notches into the
openings near
the top of the phone.
5. Snap the battery door
closed to secure the
cover into place.
Charging the battery
You must have at least a partial charge in the
battery to make or receive calls.
To charge the battery:
1. Connect the AC adapter
to the jack on the
bottom of the phone.
2. Plug the adapter into a
wall outlet.
The battery icon in the upper-right corner of the
screen tells you whether the phone is:
• Charging (the icon is animated)
• Partially charged
• Fully charged
Recharging the battery
You can safely recharge the battery at any time,
even if it has a partial charge.
Note: To remove the battery, make sure the
phone is powered off.