Filter
Top Products
Chapter 3 - Contacts 3-3
1998 Nokia Mobile Phones. All Rights Reserved.
(number 1 is reserved for calling your voice mail-
box, see chapter 4 "Telephone: Telephone set-
tings" on page 4-6). For information on how to use
the speed dials, see chapter 13 "Phone interface:
Using memory - Dialling shortcuts" on page 13-5.
To set speed dials:
1 Press Speed dials in an opened contact card.
All phone number fields of the contact card
are shown.
2 Select a field to which you want to assign a
speed dial and press Change. Select a loca-
tion and press OK.
To change or remove speed dials:
1 Select the speed dial you want to change or
remove and press Change.
2 Move the selection frame to the location you
want to use and press OK. If you want to re-
move a speed dial location, choose None.
Storing DTMF tones
The Dual Tone Multi Frequency (DTMF) tones al-
low you to communicate with voice mailboxes,
computerised telephony systems, etc. For infor-
mation on how to send DTMF tones, see chapter
4 "Telephone: Managing calls - Sending DTMF
tones" on page 4-5, or chapter 13 "Phone inter-
face: Sending DTMF tones" on page 13-3.
• If you only communicate with the contact
using DTMF tones, create a contact card for
the DTMF contact.
• If you need both a voice and a DTMF phone
number for the contact, add a new field to an
existing contact card. The DTMF sequence can
be stored either in the Tel field, after the tele-
phone number, or separately, in a DTMF field.
If you store the sequence in a Tel field, the
phone number and the DTMF sequence must
be separated by one of the DTMF special char-
acters. Label the field (with Change label) so
you can identify the DTMF sequence.
The DTMF special characters are listed in the
following table:
Logs
The Contacts application shows all communica-
tion events as two logs:
• General log shows all (or certain types of)
communication events in chronological order,
see figure 3-2.
• Individual log shows a list of all communi-
cation events relating to the selected contact.
To access the logs:
1 Press Logs in the Contacts main view. The
command set changes.
2 Select the desired log type by pressing either
Individual log or General log.
To erase the contents of the log:
1 Press Clear list. A pop-up box opens to let you
define which contacts will be deleted (meas-
ured in days). The clearing procedure reflects
on the other log, as well.
To create a new contact card:
1 Open the General log.
Character Function
* and #
May be used if the DTMF
service requires them.
p (pause)
Inserts a pause of 2.5 sec-
onds in front of, or between,
DTMF digits.
w (wait)
When the “w” character is
stored in a sequence, the
rest of the sequence is not
sent until you press Send
again in the Telephone
application.
Table 3-1