Filter
Top Products
• Authentication — Select Secure to always send your
password encrypted or Normal to send your password
encrypted when possible.
• Homepage — Depending on the access point type you
are setting up, enter the web address or the address of
the multimedia message center.
• Use access point — Select After confirmation to set
the device to ask for confirmation before the
connection using this access point is created, or
Automatically to set the device to connect to the
destination using this access point automatically.
Select Options > Advanced settings and from the
following:
• Network type — Select the internet protocol type to
transfer data to and from your device. The other
settings depend on the selected network type.
• Phone IP address (for IPv4 only) — Enter the IP address
of your device.
• DNS addresses — Enter the IP addresses of the primary
and secondary DNS servers, if required by your service
provider. To obtain these addresses, contact your
internet service provider.
• Proxy server address — Enter the address of the proxy
server.
• Proxy port number — Enter the port number of the
proxy server.
WLAN internet access points
Select Menu > Ctrl. panel > Settings and Connection >
Destinations > Access point, and follow the instructions
on the display. Or, open one of the access point groups,
select an access point marked with
, and select
Options > Edit.
Use the instructions provided by your service provider to
edit the following:
• WLAN network name — Select Enter manually or
Search for networks. If you select an existing network,
WLAN network mode and WLAN security mode are
determined by the settings of its access point device.
• Network status — Define whether the network name
is displayed.
• WLAN network mode — Select Ad-hoc to create an
ad hoc network, and to allow devices to send and
receive data directly; a WLAN access point device is not
needed. In an ad hoc network, all devices must use the
same WLAN network name.
• WLAN security mode — Select the encryption used:
WEP, 802.1x, or WPA/WPA2. (802.1x and WPA/WPA2
are not available for ad hoc networks.) If you select
Open network, no encryption is used. The WEP, 802.1x,
and WPA functions can be used only if the network
supports them.
• Use access point — Select After confirmation to set
the device to ask for confirmation before the
connection using this access point is created or
Automatically to set the device to connect to the
destination using this access point automatically.
To enter the settings for the selected security mode, select
WLAN security settings.
Advanced WLAN settings
Select Options > Advanced settings and from the
following:
• IPv4 settings — Enter the IP address of your device,
the subnet IP address, the default gateway, and the IP
addresses of the primary and secondary DNS servers.
124
Settings