A SERVICE OF

logo

Route guidance
Select Menu > Applications > GPS > GPS data and
Navigation.
Start the route guidance outdoors. If started indoors,
the GPS receiver may not receive the necessary
information from the satellites.
Route guidance uses a rotating compass on the device
display. A red ball shows the direction to the
destination, and the approximate distance to it is
shown inside the compass ring.
Route guidance is designed to show the straightest
route and the shortest distance to the destination,
measured in a straight line. Any obstacles on the route,
such as buildings and natural obstacles, are ignored.
Differences in altitude are not taken into account when
calculating the distance. Route guidance is active only
when you move.
To set your trip destination, select Options > Set
destination and a landmark as the destination, or
enter the latitude and longitude coordinates.
To clear the destination set for your trip, select Stop
navigation.
Retrieve position
information
Select Menu > Applications > GPS > GPS data and
Position.
In the position view, you can view the position
information of your current location. An estimate of the
accuracy of the location is displayed.
To save your current location as a landmark, select
Options > Save position. Landmarks are saved
locations with more information, and they can be used
in other compatible applications and transferred
between compatible devices.
Trip meter
Select Menu > Applications > GPS > GPS data and
Trip distance.
The trip meter has limited accuracy, and rounding
errors may occur. Accuracy can also be affected by
availability and quality of GPS signals.
To turn trip distance calculation on or off, select
Options > Start or Stop. The calculated values remain
on the display. Use this feature outdoors to receive a
better GPS signal.
To set the trip distance and time and average and
maximum speeds to zero, and to start a new
calculation, select Options > Reset. To set the trip
meter and total time to zero, select Restart.
Positioning settings
Select Menu > Ctrl. panel > Settings and General >
Positioning.
Positioning methods
Select from the following:
87
Positioning (GPS)