Filter
Top Products
8. NBDP PREPARATIONS
8-4
2. If [Create] is not underlined, press the →, ↑ and Enter keys to underline it.
3. With [Station] selected, enter station name using up to 18 characters.
4. Press the ↓ key to select [ID Code]. Enter station ID code.
5. Press the ↓ key to select [Mode]. Select either communication mode with the ←
or → keys.
[ARQ]: Automatic Retransmission Request
[FEC]: Forward Error Correction
6. Press the ↓ key to select [CH/Table]. Select [Channel] or [ScanTable].
7. Press the ↓ key to select [Num/Table].
If you selected [Channel] at step 6
, enter ITU channel number (see Appendix 2)
or User channel number. Go to step 10.
If you selected [ScanTable] at step 6
, press the → key to show the scan group list
registered. For the scan group, refer to section 8.5.
8. Select a scan group name by using the ↓ or ↑ key then press the Enter key. For
IB-583, go to step 10. For IB-585, go to the next step.
Example window for Scanning Group List
9. Press the ↓ key to select [Rephasing]. Select [ON] or [OFF].
Note: The default setting is [ON]. Select [ON] under normal use.
10. Press the Enter key. The prompt [OK/Cancel] asks for verification of data.
11. If the data is correct, press the Enter key. (To cancel entry, press the ↓ key to se-
lect [Cancel] then press the Enter key. Data entered are erased.) The station
name entered at step 3 appears at the [Station List] window.
12. To register other stations, press the Enter key twice then repeat steps 3 through
10.
13. Press the ↓ key. Check data on the [Station List] for correctness. The stations dis-
played in reverse video on the [Station List] are displayed on [Station Set Up].
14. Press the Esc key to quit.
Note 1: If you enter a station which already exists, the indication "Station by that name
already exists. Press any key to escape." appears. Press any key to return to the [Sta-
tion List]. Check the list.
Note 2: The station entry beginning with "DSC" is special entry which is automatically
registered by DSC function.
INTREPID