Filter
Top Products
10. NBDP TRANSMISSION, RECEPTION
10-8
10.6 Timer Operation
A built-in timer permits automatic transmission and reception of telex messages.
10.6.1 How to enable timer operation
1. Press the function key F3 to open the [Operate] menu.
2. Press the 7 key to open the [Timer Operation List].
3. Press the ↑ or ↓ key to select the operation (name) to execute.
4. Press the Enter key. An asterisk appears beside the operation selected and "T.
Op" appears in reverse video on the communication status screen. If a file stored
on a floppy disk or an SD card is to be sent, be sure the floppy disk or the SD card
containing the file is inserted in the drive.
5. If desired, select another operation (name) then press the Enter key.
6. Press the Esc key.
When the predetermined time has passed, the NBDP terminal unit automatically
sends or receives the message. The results of timer operation are displayed as either
[OK] or [NG] (No Good) on the [Timer Operation List] window. For transmission, [OK]
is displayed when the message is perfectly (100 percent) sent. For receiving, [OK] is
displayed when connecting the timer operation then disconnecting.
10.6.2 How to stop timer operation
1. Press the function key F3.
2. Press the 7 key.
3. Press the ↑ or ↓ key to select the operation (name) which has an asterisk attached
to it then press the Enter key. Remove all asterisks to cancel all timer programs.
"T. Op" disappears from the communication status screen.