Filter
Top Products
2-1
2. SSB RADIOTELEPHONE
You can do SSB communications from any screen which displays the communication
frequency.
2.1 How to Select the Class of Emission
You can select the class of emission from among the following:
• [SSB]: Single Sideband
• [TLX]: Telex
• [AM]: AM (RX only)
• [FAX]: FAX (RX only. Connect a FAX to this equipment to print FAX messages.)
At the RT screen, select the class of emission as follows:
1. Rotate the ENTER knob to highlight the class of emission (default: [SSB]) then
push the knob. When you rotate the ENTER knob clockwise, the cursor moves
from [CH] downward.
2. Rotate the ENTER knob to select the class of emission desired then push the
knob. AGC is automatically turned on or off according to the class of emission.
3. You can change AGC as below.
1) Rotate the ENTER knob to select the AGC mode indication then push the
knob.
2) Rotate the ENTER knob to select [OFF], [SLOW] or [FAST] then push the
knob.
2.2 How to Select the Channel, Frequency
Select the channel or transmitting/receiving frequency to use for the SSB.
Note: To set the SSB radiotelephone to 2182 kHz/J3E, press the 2182 key.
• [SSB]: [FAST] • [TLX], [FAX]: [OFF] • [AM]: [SLOW]
Class of
emission
AGC mode
(Automatic Gain
Control)
This icon appears
when the frequency
is for distress.