Filter
Top Products
11. MAINTENANCE & TROUBLESHOOTING
11-7
2. Select [Change] at [Setup].
3. Select [Self Test] at the bottom of the screen.
4. Press the Enter key. The results of the self test are displayed a short time later.
Selftest results for IB-583
Selftest results for IB-585
Self test results
The test results are shown as [OK] or [NG] (No Good). For any [NG], check the con-
nection of the equipments then try the self test again. If it appears again, call for ser-
vice. When the test is completed, the message "Selftest Completed. Press any key to
escape." appears.
11.7.5 Power fuse
If you can not turn on the power for IB-585, check the power fuse. If the fuse has
blown, replace the fuse (Type: FGBO-A 125V 3A PBF). If the fuse blows again after
replacement, request service.
11.7.6 Notification messages
IB-585
Notification message Meaning Remedy
Caution: This Editor cannot edit
over 16Kbytes
Can not edit the files over 16 ki-
lobytes.
Can not open the files over 16
kilobytes. Delete unnecessary
characters so that the file size is
less than 16 kilobytes.
Station by that name already
exists.
The station name already ex-
ists.
Change the station name.
Station memory is full. The station memory is full. Delete unnecessary stations.
Scan group by that name al-
ready exists.
The scan group name already
exists.
Change the scan group name.
X.XX: Version No.
*: "NG" and "Printer not ready"
when printer is off or abnormal.
IB-583
Main terminal soft (T-CPU board)
NBDP modem
XX: Version No.
xx: FS-1575, FS-2575 or FS-5075
*1: “NG” when the SD card is not inserted.
*2: “NG” when FS-xx75 is turned off.
*3: "NG" and "Printer not ready" when
printer is off or abnormal.
*4: The message “Press 3 keys” appears.
Press any three keys.