BMC Software, Inc., Confidential and Proprietary Information
312 Application Enhancement Solutions Messages Manual
BMC93131W FILE ddname, IN CICS applid, IGNORED FOR FILE SHARING, FILE IS
NOT ENABLED
Explanation: Module ARVRFSC0 of APPLICATION RESTART CONTROL
(AR/CTL) for VSAM has detected that the identified file (ddname) in the identified
CICS (applid) is not in an enabled state in CICS. The file is ignored for file sharing.
System Action: Processing continues.
User Response: No action is required if the file is supposed to be disabled. If the
file should take part in file sharing, set the file to an enabled state in CICS.
BMC93132I RETURN FROM XFCSREQC EXIT, FILE = ddname, STATUS = {OPENED
| CLOSED | ENABLED | DISABLED}
Explanation: The XFLSREQC exit program (ARVRFCXT) of APPLICATION
RESTART CONTROL (AR/CTL) for VSAM was invoked because the file status of
the indicated file (ddname) was altered in CICS. The AR/CTL for VSAM file table
was updated to reflect the new status.
System Action: Processing continues.
User Response: This message is for your information only. No action is necessary.
BMC93133I DFHIRP=vvvv, CICS SUBSYSTEM={YES | NO}, XCF={YES | NO}, XCF
LEVEL={OK | LOW}, CONNECTED MVS SYSTEM=nnnn, CONNECTED
CICS SYSTEM=mmmm
Explanation: Module ARVRCLVL of APPLICATION RESTART CONTROL
(AR/CTL) for VSAM has checked the availability of resources in the MVS system
or SYSPLEX. For problem diagnosis purposes, this message reports as much of the
following information as is available (some may be unavailable at times):
DFHIRP
The version and release of module DFHIRP in the MVS system.
CICS SUBSYSTEM
Whether the CICS subsystem is available in the MVS system.
XCF Whether the Coupling Facility is available.
XCF LEVEL
Whether the available XCF level is adequate or low for DFHIRP operation
(available only if XCF=YES).
CONNECTED MVS SYSTEM
The number of MVS systems connected to the Coupling Facility (available
only if XCF LEVEL=OK).
CONNECTED CICS SYSTEM
The number of CICS regions connected to the CICS group (available only if
XCF LEVEL=OK).
