BMC Software, Inc., Confidential and Proprietary Information
54 Application Enhancement Solutions Messages Manual
BMC11169E Duplex REGISETs unusable. Consolidated subsystem terminating.
<bcssid>
Explanation: A physical error has occurred on the last, or only, duplex
registration data set. This message should be preceded with the message
BMC11168E, which indicates the specific error that occurred.
System Action: The BCSS terminates so that the problem with the affected
registration data set(s) can be corrected. The BCSS indicates that Failsoft mode is
active and that all potentially compressed data should be processed by the expansion
routines.
Unless previously disabled from doing so, the BCSS provides the following
information to any BMC Software product requesting its service:
• Failsoft mode is active.
• All potentially-compressed data should be processed by the expansion routines.
User Response: Correct the problem with the duplex registration data set(s), then
restart the BCSS.
BMC11171E <ddname> being dropped from processing, continuing with remaining
primaries. <bcssid>
Explanation: An I/O error or initialization error (for example, mismatched
REGISETs) caused this REGISET to be out of sync with the others. The run may
continue if there are sufficient primary registration data sets remaining. <ddname>
indicates the DD statement associated with the registration data set that has dropped.
System Action: The named REGISET is excluded from further processing. Run
continues.
User Response: Correct to reason for the REGISET failure, and recycle the
subsystem.
BMC11173E <ddname>,REGISET dropped for reason(X’<reason>’),<reasontext> is
now down-level. <bcssid>
Explanation: A registration data set has been dropped. <ddname> indicates the
DD statement associated with the registration data set that has dropped. <reason>
and <reasontext> indicate the reason the registration data set has dropped in
hexadecimal and character formats. This message indicates a serious problem.
System Action: A slip dump (SDUMP) is produced, and processing continues.
User Response: Contact BMC Software Product Support.
