Filter
Top Products
HP StorageWorks 2000 G2 Modular Smart Array Reference Guide 101
245 Informational An existing disk channel target device is not
responding to SCSI discovery commands.
Check the indicated target device for bad
hardware or bad cable, then initiate a
rescan.
246 Warning The coin battery is either not present, or it is
not properly seated, or it has reached end of
life. (The battery is a battery backup for the
real-time (date/time) clock. In the event of a
power failure, the date and time will revert to
January 1, 1970 00:00:00.
The coin battery is on the controller module.
A service technician must replace or reseat
the battery.
247 Warning The FRU-ID SEEPROM for the specified field
replaceable unit (FRU) cannot be read;
FRU-ID data might not be programmed.
FRU-ID data includes the worldwide name,
SCSI ID, and branding information.
A service technician can reprogram FRU-ID
data.
248 Informational A valid feature license was successfully
installed. See event 249 for details about
each licensed feature.
249 Informational A valid license has been installed for the
specified feature. This event is logged for
each licensed feature to show the new
license value for that feature.
250 Warning A license could not be installed (license is
invalid).
Check license parameters against what is
allowed for the platform and recreate the
license using valid parameters, then reinstall.
Review the readme file that came with the
license.
251 Warning A volume-copy operation has started for the
specified source volume.
252 Informational Snapshot write data on the specified master
volume has been deleted.
256 Informational The specified snapshot has been created but
not committed. A commit action is required
before the snapshot can be used.
257 Informational The specified snapshot has been created and
committed.
258 Informational The specified snapshot has been committed
and is ready for use.
259 Informational In-band CAPI commands have been
disabled.
260 Informational In-band CAPI commands have been
enabled.
261 Informational In-band SES commands have been disabled.
262 Informational In-band SES commands have been enabled.
263 Warning The specified disk spare is missing. It was
either removed or is not responding.
Replace the specified disk.
264 Informational The link speed of the port bypass circuit and
interconnect mode has been set to the
default.
Table 14 Event code descriptions and recommended actions (continued)
Event
code
Event type Description Recommended action